Using XML
To use auto configuration using xml, GPRS.xml file is required. Here is an example of GPRS.xml.
Note that you must set [SET_GPRS], [GPRS_INSTALL] should set to 1 in M3.ini
In the XML file, you can set Connection Name, UserName, Password, APN as below.
|
<wap-provisioningdoc>
<characteristic type="CM_GPRSEntries">
<!--Connection Name: Sample-->
<characteristic type="Sample">
<parm name="DestId" value="{436EF144-B4FB-4863-A041-8F905A62C572}"/>
<!--UserName: -->
<parm name="UserName" value="" />
<!--Password: -->
<parm name="Password" value="" />
<!--Domain: -->
<parm name="Domain" value="" />
<characteristic type="DevSpecificCellular">
<parm name="BearerInfoValid" value="1"/>
<parm name="GPRSInfoValid" value="1"/>
<parm name="GPRSInfoProtocolType" value="2"/>
<parm name="GPRSInfoL2ProtocolType" value="ppp"/>
<!--APN: XXX -->
<parm name="GPRSInfoAccessPointName" value="XXX"/>
<parm name="GPRSInfoAddress" value=""/>
<parm name="GPRSInfoDataCompression" value="1"/>
<parm name="GPRSInfoParameters" value=" "/>
</characteristic>
</characteristic>
</characteristic>
</wap-provisioningdoc>
|
Copy GPRS.xml file into \Flash Disk\StarUp folder. And set install values of [SET_GPRS] and [GPRS_INSTALL] to 1 in M3.ini.
|
[SET_GPRS]
Install= 1
[GPRS_INSTALL]
Install=1
InstallFile=\Flash Disk\Driver\WWAN_Manager.CAB
|
Save the changes in M3.ini then copy back to the device followed by reset.
